Sewer and Drain Cleaning

Clear grease, roots and debris, and inspect the pipe so the clog doesn’t keep coming back.

Sewer and drain cleaning clears the grease, roots, scale and debris that slow a line down or stop it altogether. We don’t treat every clog the same way. A camera inspection tells us what we’re clearing and whether the pipe behind the clog is cracked, sagging or sound.

Trenchless Today has been cleaning and repairing sewer and drain lines since 2001, with local crews in every area we serve. If the pipe itself is damaged, cleaning is only the first step, and we’ll tell you that before we leave the job at a temporary fix.

Snaking vs. Hydro Jetting

A cable, or snake, bores a hole through a clog so water can move again. That’s often enough for a simple blockage close to a fixture. It doesn’t clean the pipe wall, and roots or grease often grow back into the same spot.

Hydro jetting uses high-pressure water to cut and flush material off the entire wall of the pipe. It’s the better choice for recurring clogs, grease in a kitchen line, root intrusion, or a line that needs to be clean before it’s lined. If rust or mineral scale has narrowed the pipe, pipe descaling may be part of the work.

Warning Signs

  • slow drains at more than one fixture
  • gurgling or bubbling in a toilet or shower
  • sewer odors
  • water backing up into a tub or floor drain
  • a clog that returns a few weeks after it’s been cleared

Those signs can also mean the pipe is broken. That’s why we start with a sewer camera inspection whenever the symptoms point past a simple fixture clog.

When Cleaning Isn’t the Whole Repair

If the camera shows cracks, separated joints or a collapse, the line needs trenchless pipe lining or pipe bursting, not another cleaning. We’d rather show you that on video than come back every few months to clear the same spot.

Find your city on our service areas page. Call (866) 926-2329 or schedule service.

Frequently Asked Questions

What’s the difference between snaking and hydro jetting?

Snaking punches an opening through a clog. Hydro jetting scours the pipe wall with high-pressure water and flushes the debris out. Jetting is more thorough and is often the better choice for grease, roots and recurring backups.

Why do drains keep clogging after a cleaning?

The clog may have been only part of the problem. Roots, grease and scale grow back if the pipe isn’t fully cleaned, and a crack or offset joint will keep catching debris until the pipe is lined or replaced.

Do you inspect the line first?

Yes, when the symptoms suggest more than a simple fixture clog. A camera inspection shows us what we’re cleaning and whether the pipe is damaged.

Can drain cleaning fix a broken pipe?

No. Cleaning removes what’s blocking the line. It doesn’t seal cracks or rebuild a collapsed pipe. If the camera shows structural damage, we’ll recommend lining or replacement.

When should I call for sewer drain cleaning?

Call when more than one drain is slow, a toilet gurgles, you smell sewer gas, or a clog has come back. Call (866) 926-2329 and we’ll take it from the inspection forward.

The plumber removes the blockage in the pipes
A diagram of a white sink with a faucet and visible piping, ideal for illustrating drain cleaning. One red tube enters the sink’s drain, while a white tube connects to the plumbing below. The pipes are shown in cross-section.

Call (866) 926-2329 and we’ll inspect the line, then clean it the way the camera says it needs.